Control and automate displays, video sources, audio processors, amplifiers, shades, lighting and much more. Any device controllable by IR, RS232 or IP can be connected. Voltage sensing, routable IR, bidirectional RS232, analog inputs and digital inputs/outputs allow for a wide array of automation and control possibilities.

Project Editor Software allows code-free device set-up, macro development and totally customizable GUI creation. GUIs are rendered in HTML so any web enabled device including smart phones, touch screens and PCs can be used as control interfaces. The BitWise Touch app enables an iPhone, iPad, or iPod Touch to control the system as well.

Even though the system can operate as a standalone controller, bidirectional RS232 capability allows it to also be an easy add on to existing control systems. Add another room, more equipment, or just use it to add web enabled interface capability.
find out more

find out more

find out more

find out more

OmniTouchPro is an intuitive touchscreen interface application for any PC or PC touchscreen that provides access to security, lighting, temperature, audio/video, cameras, and much more. The product has default interface designs in various resolutions in 8 different languages, but may also be customized using HAI Automation Studio software (part number 1126).

The image shows HAI OmniTouchPro software on ili Limited OneTouch 21. The OmniTouchPro software can be installed on any Windws based PC, touchscreen or tablet providing total felexibility.
find out more

This software application allows you to convert Pronto Hex for use with BitWise. SImply cut and paste the Hex from Pronto Edit into this tool and it will provide the hex code that can be copied into the Project Editor software.
find out more

Key features:
Complies with the IEEE802.3 Ethernet, IEEE802.3u Fast Ethernet standard
Features Store-and-Forward architecture and performs filtering and forwarding at non-blocking full wire speed
Full/ Half-duplex capability on each TX ports
Automatic source address learning and aging
Support 1K MAC address
5-Port 10/100 Mbps Switch Built-in high efficiency SRAM for packet buffer
IEEE802.3x compliant full-duplex flow control, half-duplex flow control
Broadcast storm filter, runt and C RC Filtering eliminates erroneous packets to optimize the network bandwidth
Support Power saving mode by cable detection
All port-TX supports Auto-MDI/ MDIX function
Very Strong Magnetic feet to simplify installation on a CRIS mounting plate or any metal surface.
find out more

This 50x25 Module has a Female VGA connector on the front and the back allowsing VGA cables to connect securely with the locking screws.
find out more

Cat6 cable can be used for voice and data application. This cable is UTP (unshielded) with a Low Smoke Zero Halogen (LSOH) jacket. Colour - Purple.
find out more

This unit is normally installed by a BT engineer and is the property of BT and should not be touched by anyone other than a BT engineer.

This unit allows the removal consumer part of the BT master to be located in the front.
find out more

This module presents gold plated 4mm banana connectors to the front. The connectors can also unscrew providing binding post facilities. On the back a screw down terminal block is presented for easy termination. No need for any soldering.
find out more

This single gang faceplate is used where it is necessary to pass cables through a wall. The brushes in the middle of the faceplate allow cables to pass through without exposing the inside of the wall. This provides a professional finish where it is necessary to pass cables through a wall.
find out more